Dover ProGauge MagLink LX Plus - 13. DMP Density Measurement Float

Section 13 DMP Density Measurement Float
The Density Measurement Float measures continuously the average density of the fuel in the tank and it can
be installed on the DFS DMP Probe.
This float can measure the smallest change in product density within the specific density range and these
readings can be either nominal or temperature-corrected density.
These density measures can be shown real-time on the console Maglink LX4 or exported to an external
device.
There are 2 version of the Density Measurement Float:
- (6-DMP-DF GK) which measures density for gasoline
- (6-DMP-DF DK) which measures density for diesel
They can be identified by the number of bottom steel ring as the images below:
DENSITY MEASUREMENT FLOAT SPECIFICATIONS
Materials Polyacetal – NBR – Stainless steel
Dimensions
Total length: 185mm (for Diesel) – 183mm (for Gasoline)
Diameter: 49.8mm
Density Range
680kg/m3 – 800kg/m3 for Gasoline
800kg/m3 – 900kg/m3 for Diesel
M2050-PLUS MagLink LX Plus Installation Manual | Dover Fueling Solutions 55