Dover ProGauge MagLink LX Plus - 11.4.2 DMP Wiring to Belden 88760

124 pages

To Next Page

To Previous Page

11.4.2 DMP wiring to Belden 88760

NOTE: This is for wiring installations that have Belden 88760 installed. New installations

should use Belden 88770 (se the section above).

M2050-PLUS MagLink LX Plus Installation Manual | Dover Fueling Solutions 50

Main Page

Table of Contents3
Section 1 Preface6
Section 2 General Warnings7
Section 3 Introduction9
Section 4 General Indications11
Section 5 Labeling and Type Designations13
Section 6 CAN/CSA C22.3 NO. 61010-1-1214
Section 7 Installation16
Installation Warnings16
Installation Location17
Electrical Connection18
Installation Procedure18
Section 8 Console Components21
Rear Panel21
Front Panel21
Micro SD Card22
Battery Safety and Replacement22
Compatible Devices23
Device Connections to the ISB-1W Internal I.S. Barrier23
Auxiliary Board Leds25
Section 9 Probe Installation Preparation27
Probe Placement28
Product Offset Calculation29
Riser, Manhole and Junction Box Installation30
Riser Assembly30
Manhole and Junction Box31
Conduit Seal Fittings for Cables33
Probe Installation in Underground Storage Tanks36
Section 10 924B Probe Installation37
Probe Floats37
Model 924B Probe Specifications38
Section 11 Dover Magnetostrictive Probe (DMP)40
DMP-IS Technical Characteristics40
DMP Probe Installation41
Spacer Assembly (6-3/4 RA SS) and Adjustment46
DMP Probe Cable Wiring to LX Plus I.S. Barrier48
DMP Wiring to Belden 8877048
DMP Wiring to Belden 8876050
Section 12 Density Measurement Float (DMF)52
Tank Thresholds54
Section 13 DMP Density Measurement Float55
DFS Density Measurement Float Installation56
Tank Thresholds57
Calibration on First Installation57
Section 14 Sensor Support59
Intellisense™ Technology59
Mixed Multi-Drop Installation59
Smart Sensors59
Interstitial Level Sensor61
Single Level Sump Sensor-Float Switch67
Dual Float Non-Discriminating Sensors71
Discriminating Dispenser Sump/Stp Sump Sensor76
Dual Float Brine Sensors82
Interstitial Hydrocarbon Liquid Sensor with Water Indicator88
Hydrocarbon Liquid Sensor with Water Indicator93
Hydrocarbon Vapor Sensor98
Discriminating Interstitial Sensor (Optical)103
Section 15 Probe and Sensor Wiring108
Section 16 Close and Startup109
Section 17 Connections to Management Systems (POS-FCC)110
Tokheim Fuel Pos / Dialog110
Wayne Fusion111
GILBARCO Fuel Management System111
Section 18 Maintenance113
Section 19 Technical Support114
Appendix A - NWGLDE Certifications116
Appendix B - Console Dimensions118
Appendix C - Descriptive System Document - LX Plus119
Appendix D - LX Plus Field Wiring Diagram122

Dover ProGauge MagLink LX Plus - 11.4.2 DMP Wiring to Belden 88760

Table of Contents

Other manuals for Dover ProGauge MagLink LX Plus

Related product manuals