NOTICE: Be careful to not cause damage to the probe label when you install or when you
make adjustments to the spacer. The label contains important safety and product
information.
To assemble and adjust the probe spacer:
1. Bend the probe spacer around the probe head.
2. Align the holes of the 90° bends of the top and bottom strips.
3. Put the two (2) screws through the two (2) pairs of holes and fasten with the two (2) nuts. Do not
tighten the screws completely at this time.
4. To adjust the width of the spacer, move the top and bottom strips nearer to or away from each
other. This will cause the outer diameter of the vertical strips to move in or out until you find the
correct fit inside the riser. When the correct fit has been found, tighten the screws completely.
M2050-PLUS MagLink LX Plus Installation Manual | Dover Fueling Solutions 47
To Next Page
Loading...
