,QVWUXFWLRQVIRUXVH_ X-am
®
8000
en_ Conventions in this document
2.2 Trade marks
The brands listed are only registered in certain
countries and not necessarily in the country in which
this material is sold.
2.3 Typographical conventions
2.4 Glossary
2.5 Abbreviations
Brand Brand owner
X-am
®
Dräger
Bluetooth
®
Bluetooth SIG, Inc.
Text Text in bold identifies labels on the device
and text on the display.
► This triangle in warnings identifies the
options available for avoiding the hazard.
> The greater-than symbol identifies a naviga-
tion path in a menu.
This symbol indicates information that may
make the use of this product easier.
Term Description
Operation sig-
nal
A periodic optical (green LED) and/or
acoustic signal.
Measurement
mode
Measurement in one of the applica-
tions (monitoring, clearance mea-
surement, leak search, benzene/pre-
tube measurement) (X-am 8000
only).
Monitoring Monitoring without pump (diffusion)
Monitoring with pump (with pump
adapter)
Capture range The capture range refers to a mea-
sured value range within which minor
variations in measured values (such
as signal noise, variations in concen-
tration) do not cause variations in the
display. Measured values outside the
capture range will be displayed with
the actual measured value.
Confined space
entry wizard
Measurement with pump and any
accessories (e.g. hose, probe) for
clearance measurements of specific
areas (X-am 8000 only).
Leak search
wizard
Leak search measurement (X-am
8000 only)
Benzene/pre-
tube wizard
Benzene/pre-tube measurement (X-
am 8000 only)
Peak Peak value
Quick bump
test
Test for alarm triggering.
Extended bump
test
Test for accuracy and alarm trigger-
ing.
Special state If a special state is signalled, the user
is not warned of gas concentrations
which may be dangerous.
The following device features are
special states:
First set-up/configuration with the
PC, switch-on sequence, menu,
preparation phase of the wizards,
maintenance wizard bump test and
calibration, warm-up 1 of the sensors,
device error, measuring channel
error.
D-Light The D-Light feature allows the user to
check and indicate compliance with
certain settings.
Physical sen-
sors
The CatEx, IR, and PID sensor types
are designated as physical sensors.
There are also the electrochemical
sensors.
Abbreviation Explanation
A1 Pre-alarm
A2 Main alarm
CSE Confined space entry, clearance mea-
surement (before entering confined
spaces)
IR Infrared
PID Photoionization detector
Term Description
To Next Page
Loading...
Need help?
General
