DRAFT 20 June 2005
Jaundice Meter Instructions for Use (MU01380) Page 5 - 5
Setting the Number of Average Measurements
1. Set the Power switch to On or press
the Reset button to prepare the
instrument for measurement.
• n-1, n-2, and so on (up to n-5)
will appear.
2. Press the Reset button for 5 seconds. The number of average
measurements will switch as follows:
3. Release the Reset button when the required number of average
measurements is displayed.
•If n-2 through n-5 is selected,
AV G appears in the upper left
corner of the display.
• The selected number of average
measurements will be recorded.
To Next Page
Loading...
