Dräger Oxylog 1000 User Manual

Operation
Oxylog 1000 Device Check
Operation
Oxylog 1000 Device Check
The device check must be carried out before each use.
Any operation of the device requires thorough knowledge
of the Instructions for Use.
Type:
Serial No.
Check the following points before starting up
the device:
• 02 pressure supply connected
• Cylinder pressure at least 100 bar or ventilator
connected to the central O 2 supply
• Ventilation valve and ventilation hose connected
Testing correct operation
• Fit the test lung to the ventilation valve.
Set the device:
MV
Freq.
Paw Alarm
Main switch
Switch
approx. 10 L/min
approx. 20 bpm
approx. 55 mbar
I (ON)
No Air Mix
Oxylog 1000 must ventilate the test lung.
• Squeeze the test lung, so that the airway pressure is
approx. 60 mbar.
The »Paw J *« indicator turns red,
and the audible alarm is sounded.
• Remove the test lung:
The »Paw « indicator turns red,
and the audible alarm is sounded.
In the event of deviations, see "Troubleshooting" in these
Instructions for use.
Device check completed
Name: _
Date: _
6

Dräger Oxylog 1000 Specifications

General

Brand	Dräger
Model	Oxylog 1000
Category	Fan
Language	English