Dräger Primus Series User Manual

Standby Screen
Primus activates the standby mode after successful test completion,
and will display the standby screen.
From the standby screen, you can access the following functions:
• Pre set carrier gas, O
2
concentration and fresh gas ow
• Set age
• Set ideal body weight
• Restore site default settings
• Set alarm limits
• Self test results display
• Perform the leak test
• Delete trends
• Default conguration
(password protected - held by Key Users and Dräger)
• Access monitoring mode
Monitoring Mode
In monitoring mode, the Primus will measure and display gas measurements.
There is no fresh gas delivery or ventilation capability. If ventilation is required,
set the appropriate gas ow, select the appropriate ventilation mode and
press the rotary control knob to conrm.
9
Operation

Dräger Primus Series Specifications

General

Type	Anesthesia Workstation
Display	Color Touchscreen
Power Supply	AC Mains (100-240V, 50/60Hz)
Backup Battery	Minimum 30 minutes (depending on configuration and usage)
Tidal Volume Range	20 to 1500 mL
Respiratory Rate	4 to 100 bpm
Inspiratory Time	0.2-5.0 sec
PEEP	0-20 mbar
Gas Supply	O2, N2O, Air
Alarms	Apnea, Gas Supply
Ventilation Modes	Manual, Pressure Support, SIMV
O2 Flush	35 to 45 L/min