Dräger Resuscitaire WBR82 - Page 96

PROPRIETARY AND CONFIDENTIAL DRAFT 5 Feb 04
5 - 8
Resuscitation Module Controls, Indicators, and Connectors
The actual display may differ in appearance or configuration.
Name Description
Suction gauge Displays the suction level from 0 mmHg (0 cmH
2
O) to
200 mmHg (107 cmH
2
O) of vacuum.
Suction control Adjusts the suction level from 0 mmHg (0 cmH
2
O) to 150 mmHg
(80 cmH
2
O).
Suction On/Off switch Turns the suction on and off. (Gas supply must be turned on.)
Patient Outlet Accepts the primary gas tubing. If the blender option is installed,
it delivers blended gas. Otherwise, it delivers 100% oxygen.
Flow Rate (LPM) control Adjusts the patient gas flow from 0 LPM to 15 LPM.
Airway Pressure port (if equipped) Provides a connection for the airway pressure gauge to the breath-
ing circuit.
Airway Pressure gauge (only works
with Primary Flow)
Displays the airway pressure from -1 kPa (-10 cmH
2
O) to 8 kPa
(80 cmH
2
O).
Patient Outlet 2 Connection for the gas delivery line at the hose barb connection
on the front panel. If the blender option is installed, it delivers
blended gas. Otherwise, it delivers 100% oxygen. Use tubing with
an inner diameter of 0.25" (0.64 cm).
Flow Rate 2 (LPM) control Adjusts the patient gas flow from 0 LPM to 15 LPM for Patient
Outlet 2.