Draminski iScan mini - Loading Presets; How to Freeze the Image; Measurements; Distance

19
DRAMIŃSKI iScan mini – user guide
9.2.2. Loading presets
In order to load the settings saved in the preset:
1. Open the Menu and select Presets.
2. Select an appropriate preset.
3. Conrm with the OK button.
9.3. How to freeze the image
In order to freeze the image, press Freeze or ON/OFF.
The FREEZE message will appear in the upper zone of the screen.
Once the image is frozen, you can go up to 512 frames back.
In order to view the cine loop frame by frame, briey press the left of right arrow. In order to view the loop
continuously, press and hold the left or right arrow. In order to stop the cine loop in a selected moment, again
use the left or right arrow.
Pressing one of the buttons again unfreezes the image.
9.4. Measurements
The ultrasound scanner is equipped with tools for measuring of: distance, area, automatic follicle measure-
ment.
9.4.1. Distance
In order to measure distance:
1. Freeze the image.
2. Open the Menu.
3. Go to Measure.
4. Select Distance.
5. A red marker will appear on the screen. Set it in a selected area using the arrows.
6. Conrm the position of the marker by pressing OK.
7. Another marker will appear on the screen. Follow the steps 5 and 6.
8. The measurement result will be shown in the bottom left corner of the screen.
The user can perform up to 4 measurements in one image.
9.4.2. Area
The area is calculated based on two sections, according to the formula: P=AxB.
The result is presented in cm2.
In order to measure area of a structure:
1. Freeze the image.
2. Open the Menu and move to the Measure tab.
3. Select Area.
4. Set two measuring sections as in section <9.7.1>.
Attention! When using a mobile application, you can draw an outline around any shape and measure
its area.