DRAMIŃSKI iScan mini – user guide
20
9.4.3. Follicle
The measurement is used to automatically determine the largest dimension of a follicle. For a correct measure-
ment as clear image of the follicle as possible has to be obtained.
The result is presented in mm.
In order to measure a follicle:
1. Freeze the image.
2. Open the Menu and move to the Measure tab.
3. Select Follicle.
4. By using direction arrows place the cursor in the centre of the follicle.
5. Conrm the position of the cursor with OK.
6. If needed use the UP / DOWN arrows to adjust sensitivity and LEFT / RIGHT to adjust the shape of the
outline.
9.5. How to save data
The ultrasound scanner has internal memory able to save 200 cine loops and 200 images.
9.5.1. Saving images
In order to save the image:
1. Freeze the image and open Menu.
2. Move to the Database tab and select Save Image.
3. A message will be displayed on the screen: “Do you want to add description? Yes / No.”
4. If you decide to add a description, enter the characters using the Up / Down arrows and the Left / Right
arrows. Approve by pressing “V”.
Attention! The image can be saved with the marked measurements. The measurements are described
in the section: <9.5>.
9.5.2. Saving cine loops
In order to save the cine loop, follow the steps described above, selecting Save Cine loop in the Database Menu.
9.6. How to load the data onto the screen
9.6.1. Loading an image
In order to load the image:
1. Open the Menu and move to the Database tab.
2. Select Browse.
3. Select a le from the list in order to display it. Each le has a thumbnail of the image.
4. Conrm with the OK button.
5. After loading the image, you may move to a previous / next image by using the LEFT/RIGHT arrows. Loops
will not be loaded in this mode.
9.6.2 Loading a cine loop
In order to load the cine loop, follow the steps described above, selecting Load Cine loop in the Database
Menu.
Once the cine loop is loaded, start the video playback on the screen using the UP/DOWN arrows.
To Next Page