Vigor3200 Series User’s Guide
131
IP Pool Counts - Enter the maximum number of PCs that
you want the DHCP server to assign IP addresses to. The
default is 10.
Use LAN Port – Specify an IP for IP Route Subnet. If it is
enabled, DHCP server will assign IP address automatically
for the clients coming from P1 and/or P2. Please check the
box of P1 and P2.
Use MAC Address - Check such box to specify MAC
address.
MAC Address: Enter the MAC Address of the host one by
one and click Add to create a list of hosts to be assigned,
deleted or edited IP address from above pool. Set a list of
MAC Address for 2
nd
DHCP server will help router to
assign the correct IP address of the correct subnet to the
correct host. So those hosts in 2
nd
subnet won’t get an IP
address belonging to 1
st
subnet.
Add – Type the MAC address in the boxes and click this
button to add.
Delete – Click it to delete the selected MAC address.
Edit – Click it to edit the selected MAC address.
Cancel – Click it to cancel the job of adding, deleting and
editing.
After finishing all the settings here, please click OK to save the configuration.
4
4
.
.
2
2
.
.
3
3
S
S
t
t
a
a
t
t
i
i
c
c
R
R
o
o
u
u
t
t
e
e
Go to LAN to open setting page and choose Static Route.
Each item is explained as follows:
Item Description
Index
The number (1 to 10) under Index allows you to open next
page to set up static route.
Destination Address
Displays the destination address of the static route.
Status
Displays the status of the static route.
Viewing Routing Table
Displays the routing table for your reference.
To Next Page
Loading...
Need help?
General
