Vigor3200 Series User’s Guide
314
Item Description
click Disable to close the mechanism of notification.
STUN Settings
The default is Disable. If you click Enable, please type the
relational settings listed below:
Server IP – Type the IP address of the STUN server.
Server Port – Type the port number of the STUN server.
Minimum Keep Alive Period – If STUN is enabled, the CPE
must send binding request to the server for the purpose of
maintaining the binding in the Gateway. Please type a number
as the minimum period. The default setting is “60 seconds”.
Maximum Keep Alive Period – If STUN is enabled, the CPE
must send binding request to the server for the purpose of
maintaining the binding in the Gateway. Please type a number
as the maximum period. A value of “-1” indicates that no
maximum period is specified.
After finishing all the settings here, please click OK to save the configuration.
4
4
.
.
1
1
5
5
.
.
3
3
A
A
d
d
m
m
i
i
n
n
i
i
s
s
t
t
r
r
a
a
t
t
o
o
r
r
P
P
a
a
s
s
s
s
w
w
o
o
r
r
d
d
This page allows you to set new password.
Available parameters are explained as follows:
Item Description
Old Password
Type in the old password. The factory default setting for
password is “admin”.
New Password
Type in new password in this field.
Confirm Password
Type in the new password again.
When you click OK, the login window will appear. Please use the new password to access
into the web configurator again.
To Next Page
Loading...
Need help?
General
