Vigor3200 Series User’s Guide
16
Note: There are five WAN selections available for you to choose. In which, WAN5 is
selected for 3G USB modem connection. Refer to the following for detailed information.
2
2
.
.
3
3
.
.
1
1
F
F
o
o
r
r
W
W
A
A
N
N
1
1
–
–
W
W
A
A
N
N
4
4
Choose WAN1/WAN2/WAN3/WAN4 and click Next. On the next page as shown below,
please select the appropriate Internet access type according to the information from your ISP.
For example, you should select PPPoE mode if the ISP provides you PPPoE interface. Then
click Next for next step.
2
2
.
.
3
3
.
.
1
1
.
.
1
1
P
P
P
P
P
P
o
o
E
E
PPPoE stands for Point-to-Point Protocol over Ethernet. It relies on two widely accepted
standards: PPP and Ethernet. It connects users through an Ethernet to the Internet with a
common broadband medium, such as a single DSL line, wireless device or cable modem. All
the users over the Ethernet can share a common connection.
PPPoE is used for most of DSL modem users. All local users can share one PPPoE connection
for accessing the Internet. Your service provider will provide you information about user name,
password, and authentication mode. If your ISP provides you the PPPoE connection, please
select PPPoE for this router.
1. Choose WAN1/WAN2/WAN3/WAN4 as the WAN Interface and click the Next button.
The following page will be open for you to specify Internet Access Type.
To Next Page
Loading...
Need help?
General
