Vigor3200 Series User’s Guide
245
Item Description
policy can be viewed as one pure L2TP connection.
z Nice to Have - Apply the IPSec policy first, if it is
applicable during negotiation. Otherwise, the dial-in VPN
connection becomes one pure L2TP connection.
z Must -Specify the IPSec policy to be definitely applied
on the L2TP connection.
SSL Tunnel - It allows the remote dial-in user to make an SSL
VPN Tunnel connection through Internet, suitable for the
application through network accessing (e.g.,
PPTP/L2TP/IPSec)
If you check this box, the function of SSL Tunnel for this
account will be activated immediately.
Specify Remote Node - Check the checkbox to specify the IP
address of the remote dial-in user, ISDN number or peer ID
(used in IKE aggressive mode). If you uncheck the checkbox,
the connection type you select above will apply the
authentication methods and security methods in the general
settings.
Netbios Naming Packet
z Pass – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel
while connecting.
z Block – When there is conflict occurred between the
hosts on both sides of VPN Tunnel in connecting, such
function can block data transmission of Netbios Naming
Packet inside the tunnel.
Multicast via VPN - Some programs might send multicast
packets via VPN connection.
z Pass – Click this button to let multicast packets pass
through the router.
z Block – This is default setting. Click this button to let
multicast packets be blocked by the router.
Subnet
Chose one of the subnet selections for such VPN profile.
Assign Static IP Address – Please type a static IP address for
the subnet you specified.
SSL VPN
Set SSL Web Proxy - It allows the remote dial-in user to
access internal web over SSL VPN, suitable for the application
through web only (e.g., HTTP). Click SSL VPN>> SSL Web
Proxy to set profiles.
If you have set several profiles beforehand, you can check SSL
Web Proxy and choose the one(s) you need as SSL VPN.
To check if SSL Web Proxy is activated or not, please open
To Next Page
Loading...
Need help?
General
