Vigor2920 Series User’s Guide
156
Enable this account Check the box to enable this function.
Idle Timeout- If the dial-in user is idle over the limitation of
the timer, the router will drop this connection. By default, the
Idle Timeout is set to 300 seconds.
PPTP Allow the remote dial-in user to make a PPTP VPN connection
through the Internet. You should set the User Name and
Password of remote dial-in user below
IPSec Tunnel Allow the remote dial-in user to make an IPSec VPN
connection through Internet.
L2TP Allow the remote dial-in user to make a L2TP VPN connection
through the Internet. You can select to use L2TP alone or with
IPSec. Select from below:
None - Do not apply the IPSec policy. Accordingly, the VPN
connection employed the L2TP without IPSec policy can be
viewed as one pure L2TP connection.
Nice to Have - Apply the IPSec policy first, if it is applicable
during negotiation. Otherwise, the dial-in VPN connection
becomes one pure L2TP connection.
Must -Specify the IPSec policy to be definitely applied on the
L2TP connection.
Specify Remote Node Check the checkbox-You can specify the IP address of the
remote dial-in user, ISDN number or peer ID (used in IKE
aggressive mode).
Uncheck the checkbox-This means the connection type you
select above will apply the authentication methods and security
methods in the general settings.
Netbios Naming Packet Pass – Click it to have an inquiry for data transmission between
the hosts located on both sides of VPN Tunnel while connecting.
Block – When there is conflict occurred between the hosts on
both sides of VPN Tunnel in connecting, such function can
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
To Next Page
Loading...
