Vigor2920 Series User’s Guide
70
To use 3G network connection through 3G USB Modem,
choose 3G USB Modem as the physical mode in WAN2. Next,
go to WAN>> Internet Access. 3G USB Modem is available
for WAN2. You can choose PPP as the access mode and click
Details Page for further configuration.
Physical Type You can change the physical type for WAN2 or choose Auto
negotiation for determined by the system.
Load Balance Mode If you know the practical bandwidth for your WAN interface,
please choose the setting of According to Line Speed.
Otherwise, please choose Auto Weigh to let the router reach
the best load balance.
Line Speed If your choose According to Line Speed as the Load Balance
Mode, please type the line speed for downloading and
uploading through WAN1/WAN2. The unit is kbps.
Active Mode Choose Always On to make the WAN connection
(WAN1/WAN2) being activated always; or choose Active on
demand to make the WAN connection (WAN1/WAN2)
activated if it is necessary.
If you choose Active on demand, the Idle Timeout will be
available for you to set for PPPoE and PPTP access modes in
the Details Page of WAN>>Internet Access. In addition, there
are three selections for you to choose for different purposes.
WAN2 Fail – It means the connection for WAN1 will be
activated when WAN2 is failed.
WAN2 Upload speed exceed XX kbps – It means the
connection for WAN1 will be activated when WAN2 Upload
speed exceed certain value that you set in this box for 15
seconds.
WAN2 Download speed exceed XX kbps– It means the
connection for WAN1 will be activated when WAN2
Download speed exceed certain value that you set in this box
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
To Next Page
Loading...
Need help?
General
