Vigor2920 Series User’s Guide
56
DMZ Host for WAN2 and WAN3 is slightly different with WAN1. See the following figure.
If you previously have set up WAN Alias for PPPoE or Static or Dynamic IP mode, you will
find them in Aux. WAN IP for your selection.
Enable
Check to enable the DMZ Host function.
Private IP
Enter the private IP address of the DMZ host, or click Choose PC
to select one.
Choose PC
Click this button and then a window will automatically pop up, as
depicted below. The window consists of a list of private IP
addresses of all hosts in your LAN network. Select one private IP
address in the list to be the DMZ host.
When you have selected one private IP from the above dialog, the
IP address will be shown on the following screen. Click OK to
save the setting.
To Next Page
Loading...
