SECTION 6 COOLING SYSTEM
Page 14
TD-25M EXTRA DRESSTA
16. Reinstall vent hose (5, Fig. 6.3) to the auxiliary tank. Tighten the clamp.
17. Refill cooling system with the coolant. Refer to Operator’s Manual.
18. Start the engine. After reaching operating temperatures, check all disconnected previously
lines: cooling, fuel and hydraulic systems for leaks. Stop the engine. Check the coolant level,
drive train oil level and hydraulic oil level as described in Operator's Manual.
WARNING! Before working on the machine be sure to turn "OFF" master switch and
take key out to prevent accidental starting.
19. Attach a suitable lifting device to the crankcase guard. Lift the guard and install the bolts.
WARNING! This procedure requires extreme caution. Use suitable blocking
equipment while under confines of machine.
20. Install air baffles (2, Fig. 6.6). Close front radiator door, install the bolts.
21. Position the hood (1, Fig. 6.2), install the bolts and tighten.
22. Reassemble side enclosure (2).
23. Reassemble the exhaust tube assy (3).
24. Reassemble the aspirator tube between the air precleaner and muffler. Install air
precleaner (4).
To Next Page
Loading...