15
Two Way Remote Control (cont’d)
Pairing camera to a remote control - one to all ‘RC 1-ALL’
A single remote control can be paired to an infinite number of cameras in a 10m
range from the remote control, to enable footage to be captured from every
angle.
1. On the camera, navigate to Settings mode using the MODE button
2. Scroll down to ‘RC 1-ALL’ using the CYCLE button and press ACTION
3. On the remote control, press ACTION—The camera will beep and return to
the Camera Settings menu if it has recognised the remote
! Any camera that does not display ‘successful’ and return to the Camera
Settings menu it will not be paired—try pressing ACTION on the remote again
4. On the camera, the icon beside Remote Pairing will change to indicate it is
paired to a remote control
! When pairing multiple cameras, always test the remote control to see if it
operates all the cameras before mounting them
Using the remote control - one to all ‘RC 1-ALL’
While the camera and remote are both powered on and paired, pressing ACTION
on the remote control will begin recording video, capture a photo, start
timelapse or photoburst, depending on the camera mode.
Pressing ACTION while recording video will capture a photo, or start Video
Tagging (if activated, (see p8). Pressing STOP will end video recording or
timelapse.
The remote contol indicator lights will show white to indicate the remote control
is paired to multiple cameras.
LED Status Description
Rapid Blinking Red Less than 15% battery life remains
Blink Red Once Taking a photo (Photo, Timelapse and Photoburst Modes)
Blinking Red Recording video (Video Mode)
Blinking Blue When the camera receives a signal from the remote control
Blinking Green Camera is in Video Mode
Blinking Yellow Camera is in Photo Mode
Blinking Purple Camera is in Timelapse Mode
Blinking Cyan Camera is in Photoburst Mode
Figure 22: Remote LED Status
To Next Page
Loading...
Need help?
General
Weight and Dimensions
