DT Research WebDT 435 - Chapter 2: Getting Started; Powering the Device On and Off

Rev Date 9/16/2010
11
Getting to Know Your WebDT 435
Getting Started with the WebDT 435
The WebDT 435 comes with a partially charged battery pack that you can
use when you start to use your WebDT 435.
Turn the WebDT 435 On and Off
To turn on the device
Use the stylus to push and hold down the POWER button on the
backside for 2 seconds.
To turn off the device
Use the stylus to push and hold down the POWER button on the
backside for 4 seconds. If you experience some sluggishness with
your device, you can perform a Hard Reset to shut down all programs
and restart your device.
Warning
You may lose data or your installed programs after you turn off the device. Be sure
to Save Settings (See page 25) or backup all important data under Resident Flash
before you turn off the device.
Chapter
2