DT Research WebDT 435 User Manual

Rev Date 9/16/2010
13
Touch Screen Calibration
The first time you turn on the WebDT 435, the system will automatically
direct you to do a screen calibration.
To calibrate the WebDT435 touch screen again, follow the steps below:
Hold the function key
and press to start calibration.
Or
Click
Start
→
Settings
→
Control Panel
→
Stylus
Select
Calibration
tab  Click
Recalibrate
button (as shown at right
side).
Follow the instructions described on the screen to complete the touch
screen calibration.
After starting to run the touch calibration, if users do not touch the
screen within 30 seconds, the operation will be automatically
terminated.
If users do not perform the calibration precise enough, then the
calibration process will be activated again until the calibration is done
precisely or cancelled by users.

DT Research WebDT 435 Specifications

General

Brand	DT Research
Model	WebDT 435
Category	Handhelds
Language	English