duagon MC50M - UEFI Firmware Configuration for PXE Boot; Installing Operating System Software

Getting Started
20MC50M00 E5

2020-10-20
33
2.4.6 Configuring the UEFI Firmware for PXE Boot
To enable PXE booting of the MC50M, configure the UEFI firmware as follows:
 For UEFI mode:
- Menu MEN: Setup Mode [Extended]
- Menu Advanced: Network Stack Configuration > Network Stack [Enabled] > IPV4
PXE Support [Enabled]
 For Legacy BIOS mode:
- Menu Advanced: CSM Configuration > CSM Support [Enabled]
- Menu Advanced: CSM Configuration > Option ROM Execution > Network [Legacy]
- Menu Advanced: CSM Configuration > Option ROM Execution > Video [Legacy]
2.5 Installing Operating System Software
By default, no operating system is installed on the MC50M.
 Please refer to the respective manufacturer's documentation on how to
implement the operating system.
 See the duagon website for all available software:
www.duagon.com/products/mc50m/#downl