duagon MC50M - Equipment Integration;Installation Compliance

EN 50155 Documentation Compliance Overview
20MC50M00 E5

2020-10-20
84
Table 40. Compliance with EN 50155, chapter 12.5 Equipment integration/installation
documentation
Requirement Compliance
Type of mechanical frame needed for
mounting the electronic equipment:
mounting frame, mounting plate, rack,
subrack, case, etc. (with references and
characteristics)
Chapter Getting Started > Mounting the
MC50M
Mechanical drawing (dimension, fixing,
mounting points)
Chapter Product Overview > Technical Data
> Mechanical Specifications
Chapter Getting Started > Mounting the
MC50M
Orientation constraints for mounting the
equipment
Chapter Getting Started > Mounting the
MC50M
Natural cooling or forced ventilation
constraints for the equipment
Chapter Product Overview > Technical Data
> Mechanical Specifications
Chapter Product Overview > Cooling
Concept
Required free space inside integration
volume for natural cooling
Chapter Product Overview > Cooling
Concept
Need of preheating or air outlet Not relevant
Need of free space for access to parts, or
for mounting – dismounting
Not relevant
Mechanical protection constraints,
screening
Not applicable
Earth terminals location Chapter Product Overview > External
Interfaces
Chapter Getting Started > Connecting an
Earthing Cable
Shielding requirements for input or
output wired signals
The MC50M requires shielded cables for
the following interfaces:
 Ethernet
 Serial (RS232/RS422/RS485)
Possible recommendation for wire gauges Chapter Getting Started > Connecting and
Starting > Connecting an Earthing Cable
Mechanical polarization or coding where
applicable
Chapter Getting Started > Connecting and
Starting > Connecting the Power Supply
External filters to add for EMC compliance Not applicable
External overcurrent protections to add:
fuses, micro circuit breakers, etc., on
power supply circuit or output circuits. (If
any, with references)
Chapter Getting Started > Connecting and
Starting > Safety Instructions for Connection
External overvoltage protections to add:
TVS, ESD protection, etc. (If any, with
references)
Not applicable