Ducati PANIGALE - Modify Pin

Modify Pin
●
Enter the SETTING MENU.
●
Select the "Pin Code" option and press ENTER

●
Select the "Modify Pin" option (Fig 93) and press
ENTER 
The display shows the message “Old Pin” and the
spaces to enter the four digits of the old pin (Fig 91).
The two arrows above and below the first digit give
the possibility to set it. Entering the code:
●
Use UP and DOWN  to increase and
decrease by 1 the value from “0” to “9”.
●
Press ENTER  to confirm the digit and
move on to the following digit.
●
Repeat the procedure until entering all 4 digits.
Once the  digit is set, press ENTER and the
instrument panel behaviour will be as follows:
●
if the pin code is not correct, the instrument
panel displays “Wrong” highlighted in red for 2
seconds and then goes back to previous screen,
to allow you to try again;
●
if the pin code is correct, the instrument panel
shows “Correct” highlighted in green for 2
seconds, and then displays the page for entering
...
Modify Pin
< Back
Fig 93
Old Pin 0 - - -
...
Fig 94
137