EasyManua.ls Logo

Dulevo 850 mini - Page 130

Dulevo 850 mini
144 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-6-
2011-09
26 / 40
850 mini
6.5.a - CONTROLLO PRESSIONE PNEUMATICI
- Verificare l’integrità e la pressione dei pneumatici.
AVVERTENZA:
Non superare mai le pressioni previste.
Pericolo di esplosione.
In fase di gonfiaggio mantenersi a lato del pneuma-
tico.
Controllare la pressione dei pneumatici attenendosi alla
tabella rifornimenti posta in fondo al presente capitolo.
6.5.b - CONTROLLO SERRAGGIO RUOTE
- Il controllo del fissaggio dadi ruote va effettuato se-
guendo gli intervalli indicati nella tabella di manuten-
zione precedente e quando si sostituisce una ruota.
- Per le modalità di sostituzione ruota attenersi a quanto
indicato nel relativo capitolo. (6.2.a).
- Le figure indicano l’ordine di chiusura dei dadi di fis-
saggio ruote.
- I dadi vanno serrati con un coppia di serraggio di
300 Nm.
NOTA:
Le coppie di serraggio indicate si intendono per viti
pulite, sgrassate e senza l’aggiunta di lubrificanti.
1
3
6
2
4
5
6.5.c - CONTROLLO LIVELLO ELETTROLITA BAT-
TERIA
Controllare che il livello dell’elettrolita della batteria di
avviamento sia corretto.
Effettuare, se necessario, il rabbocco come indicato nelle
istruzioni della batteria.
6.5.a - TIRE PRESSURE CHECK
- Check the integrity and the pressure of the tyres.
WARNING:
Never exceed the indicated tire pressures.
Risk of tire explosion.
Stand to the side of the tire while adding air.
Check tire pressure according to the 'Supplies' table at
the end of this chapter.
6.5.b - WHEEL TIGHTENING CHECK
- The tightening of wheel nuts has to be checked
according to the time intervals indicated in the
previous maintenance table and when you replace a
wheel.
- For wheel replacement modes see chapter (6.2.a).
- Figures shows the tightening order of the wheel nuts.
- Nuts have to be tightened with a torque wrench setting
of 300 Nm.
NOTICE:
The indicated torque wrench settings are meant for
clean screws, degreased and without lubricants.
6.5.c - BATTERY ELECTROLYTE LEVEL CHECK
Check that the level of the starting battery electrolyte is
correct.
If necessary, top up as indicated in the battery
instructions.

Table of Contents

Related product manuals