Duplo 660P Maintenance Manual

Cutting Table Vertical Adjustment
1) Take a full stack of paper and put it into the machine and make a cut, compare the top sheet
with the bottom sheet to see if it is at a angle or if it matches if not go to the next step.
2)
Take off the front and bottom back cover.
3) Loosen but do not remove these bolts there are 2 of them that are horizontal bolts in the front,
the other 2 of them are vertical in the back of the machine, these 4 bolts are 19mm.
4)
There are 2 smaller vertical bolts under the back of the cutting table, on the left and the right
side These are the ones that change the angle of the cutting table loosen the 2 nuts on the bolts
so you can adjust the bolts.
5) By determining the angle needed to be adjusted by the cut sheet that you have done, lower or
raise the bolts evenly on both sides, by making a cut and adjusting the bolts, till it is vertically
square.
6) Tight all the nuts and bolts and make another cut of a full stack of paper to confirm the
adjustment has not moved. If there is no change, you are finished. If so you have to re-start from
1)
until it is square.
https://www.supplychimp.com

Duplo 660P Specifications

General

Brand	Duplo
Model	660P
Category	Paper Cutters
Language	English