How To Replace The Knife Cutting Line Light
1) Take top front cover off
2)
Loosen the bolt and pull the light away from the mounting bracket
3) Disconnect the male from the female connector and remove the 2 phillip screws from the
mounting bracket and take out the old light
4) Put the new light in by connecting the male to the female connector and putting the 2 phillip's
screw back into the mounting bracket
5) Put the mounting bracket bolt back on the bar with the bracket and tighten the bolt
6) Alien the light so it is between the knife blade and the clamp so that the line can be seen on
the cutting stick
https://www.supplychimp.com
To Next Page
Loading...
