Needle cooling from above
8 Additional Instructions D867 - 01.0 - 04/2020
Fig. 5: Assembling the needle cooling (5)
19. Slide the block (17) with blow tube (18) and hose (15) onto the walking
foot bar.
20. Assemble the walking foot (13).
21. Insert the needle (14).
22. Align the blow tube (18) with the needle so that the blow tube (18) is
at the center relative to the needle eye.
Important
Turn the handwheel and check if the blow tube (18) collides with the finger
guard.
If necessary, slightly correct the position of the blow tube (18).
23. Lay the hose (15) towards the rear to the stepper motor using cable
clamps.
24. Feed the hose (15) towards the front through the hole (16) in the
machine casting.
(15) - Hose
(16) - Hole
(17) - Block
(18) - Blow tube
To Next Page
Loading...
