Needle cooling from above
Additional Instructions D867 - 01.0 - 04/2020 11
2.2 Connecting the needle cooling
Fig. 8: Connecting the needle cooling
To connect the needle cooling:
1. Tilt the machine head.
2. Connect the cable (1) at the solenoid valve (2).
3. Lay the cable (1) to PCB A2 (3) along the other cables of the machine
head.
4. Insert the cable (1) at slot X28 on PCB A2.
5. Erect the machine head.
6. Install all covers.
(1) - Cable
(2) - Solenoid valve
(3) - PCB A2
To Next Page
Loading...
