Needle cooling from below
Additional Instructions D867 - 01.0 - 04/2020 15
3.2 Connecting the needle cooling
Fig. 13: Connecting the needle cooling
To connect the needle cooling:
1. Tilt the machine head.
2. Connect the cable (1) at the solenoid valve (3).
3. Feed the cable (1) through the cable holder (2) and to PCB A2 (4).
4. Insert the cable (1) at slot X28 on PCB A2 (4).
5. Erect the machine head.
6. Install all covers.
(1) - Cable
(2) - Cable holder
(3) - Solenoid valve
(4) - PCB A2
To Next Page
Loading...
