Needle cooling from below
14 Additional Instructions D867 - 01.0 - 04/2020
12. Feed the hose (8) through cable holder (11).
13. Connect hose (8) with hose (14) using a plug nipple (12).
14. Feed the hose (14) through cable holder (13).
15. Erect the machine head.
Fig. 12: Assembling the needle cooling (4)
16. Disassemble the throat plate slide (15).
17. Loosen the screws (16).
18. Disassemble the throat plate (17).
19. Loosen the screws (19).
20. Remove the feed dog.
21. Assemble the new feed dog (18).
22. Align the feed dog (18) such that the needle pierces in the center of
the hole.
23. Tighten the screws (19).
24. Connect the hose (14) to the feed dog (18).
25. Assemble the throat plate (17).
26. Assemble the throat plate slide (15).
(14) - Hose
(15) - Throat plate slide
(16) - Screws
(17) - Throat plate
(18) - Feed dog
(19) - Screws
To Next Page
Loading...
