Needle cooling from below
Additional Instructions D867 - 01.0 - 04/2020 13
Fig. 10: Assembling the needle cooling (2)
6. Tilt the machine head.
7. If not yet present, tighten the valve block (6) with the bracket (7).
8. Remove the dummy plate from the valve block (6).
9. Screw the solenoid valve (1) in at the available space on the valve
block (6).
10. Connect the hose (8) to the throttle check valve (3).
11. Feed the hose (8) through the cable holder (9) and the cable duct (10).
Fig. 11: Assembling the needle cooling (3)
(1) - Solenoid valve
(3) - Throttle check valve
(6) - Valve block
(7) - Bracket
(8) - Hose
(9) - Cable holder
(10) - Cable duct
(8) - Hose
(11) - Cable holder
(12) - Plug nipple
(13) - Cable holder
(14) - Hose
To Next Page
Loading...
