Needle cooling from above
Additional Instructions D867 - 01.0 - 04/2020 5
2 Needle cooling from above
2.1 Assembling the needle cooling
Fig. 1: Assembling the needle cooling (1)
To assemble the needle cooling:
1. Disassemble the arm cover (1).
2. Disassemble the front cover (7).
3. Disassemble the head cover (2).
4. Disassemble the motor cover (3).
WARNING
Risk of injury from sharp and moving parts!
Puncture or crushing possible.
Switch off the machine before assembling the
needle cooling.
(1) - Arm cover
(2) - Head cover
(3) - Motor cover
(4) - Rear cover
(5) - Handwheel
(6) - Belt cover
(7) - Front cover
To Next Page
Loading...
