Dymo MobileLabeler - Getting Started

7
DYMO MobileLabeler
User Guide
Getting Started
Follow the instructions in this section to set up your label maker.
Connecting the Power
The label maker is powered by a rechargeable, lithium-polymer (LiPo) battery . The
battery included with your label maker comes partially charged.
For best performance, fully charge the battery before using your label maker.
Inserting the Battery
Make sure all cables are disconnected
before inserting the LiPo battery.
To insert the battery
1 Press and then lift to open the
side cover of the label maker.
2 Insert the battery into the battery
compartment as shown in Figure 2.
3 Close the side cover of the label
maker.
Make sure to read the LiPo Safety
Precautions found on page 2.
Removing the Battery
Remove the battery when the label maker
will not be used for more than seven days.
Make sure all cables are disconnected
before removing the LiPo battery.
To remove the battery
1 Press and then lift to open the side
cover of the label maker.
2 Remove the battery from the battery
compartment as shown in Figure 3.
Make sure to read the LiPo Safety
Precautions found on page 2.
Figure 2
Figure 3