Dymo MobileLabeler - Safety Precautions for Lithium-Polymer Rechargeable Battery; General Safety Precautions

2
DYMO MobileLabeler
User Guide
Safety Precautions for Lithium-Polymer Rechargeable
Battery
Battery Type: LiPolymer 7.4V 1500mAh 11.1Wh
Improper handling of a lithium-polymer rechargeable battery may cause leakage,
heat, smoke, an explosion, or fire. This could cause deterioration of performance
or failure. This may also damage the protection device installed in the battery. This
could damage equipment or injure users. Thoroughly follow the instructions
below.
Danger
 Use the battery only in the MobileLabeler label maker.
 Battery can only be charged while inserted in the label maker using the
charging adapter provided (9VDC/4A).
 Do not connect directly to an electric outlet or cigarette lighter charger.
 Do not store battery close to fire or inside the car where temperature may be
over 140°F (60°C).
Warning
 Stop charging the battery if charging is not completed within three hours.
Caution
 Do not use the label maker or battery in a place that generates static
electricity.
 Use the label maker only at room temperature.
 Battery can only be charged within +50°F~86°F (+10°C~30°C) temperature
range.
General Safety Precautions
Follow the guidelines in this section to use this product safely. In addition, make
sure to read the Safety Precautions for Lithium-Polymer Rechargeable
Battery on page 2.
Charging Adapter and Power Cord
 Only use the charging adapter and power cord that came with the label
maker.
 Do not handle charging adapter or power cord if your hands are wet.
 Do not cut, damage, alter, or place heavy objects on the charging adapter or
power cord.
 Do not use the charging adapter or power cord if either are damaged.
Label Maker
 Only use the USB cable that came with the label maker.
 Do not insert objects into or block the label exit slot.
 Do not touch the cutter blade. Personal injury could result.
 Do not allow any liquids to come into contact with the label maker.
 Do not disassemble the label maker. For inspection, adjustment, or repair,
contact DYMO Customer Support (http://support.dymo.com).
!
!
!