Need help?Do you have a question about the Dynacord DSP 260 and is the answer not in the manual?
Details the key features and capabilities of the Dynacord DSP 260 digital signal processor.
Details the various connectors, displays, and controls located on the front of the DSP 260 unit.
Details the various connectors and interfaces located on the rear of the DSP 260 unit.
Provides instructions and guidelines for mounting, power connection, and audio cable setup for the DSP 260.
Covers the 60 pre-configured presets available for immediate use with the DSP 260.
Guides the user on how to recall factory and user presets stored in the DSP 260's memory.
Explains the procedure for saving edited presets into user memory locations on the DSP 260.
Outlines the process of entering edit mode, standard vs. full edit, and navigating parameter screens.
Introduces the detailed description of all DSP parameters available in the DSP 260, grouped by DSP block.
Guides the selection of system configurations from predefined setups for optimal routing and processing.
Details how to set edit mode and manage front panel access controls, including lockout.
Details the key features and capabilities of the Dynacord DSP 260 digital signal processor.
Details the various connectors, displays, and controls located on the front of the DSP 260 unit.
Details the various connectors and interfaces located on the rear of the DSP 260 unit.
Provides instructions and guidelines for mounting, power connection, and audio cable setup for the DSP 260.
Covers the 60 pre-configured presets available for immediate use with the DSP 260.
Guides the user on how to recall factory and user presets stored in the DSP 260's memory.
Explains the procedure for saving edited presets into user memory locations on the DSP 260.
Outlines the process of entering edit mode, standard vs. full edit, and navigating parameter screens.
Introduces the detailed description of all DSP parameters available in the DSP 260, grouped by DSP block.
Guides the selection of system configurations from predefined setups for optimal routing and processing.
Details how to set edit mode and manage front panel access controls, including lockout.
General| Type | Digital Signal Processor |
|---|---|
| Number of Channels | 2 |
| A/D Conversion | 24-bit |
| D/A Conversion | 24-bit |
| Sampling Rate | 48 kHz |
| THD+N | < 0.01% |
| Total Harmonic Distortion | < 0.01% |
| Signal to Noise Ratio | > 100 dB |
| Crossover | Yes |
| Delay | Yes |
| Limiter | Yes |
| Display | LCD |
| Inputs | 2 x XLR |
| Outputs | 2 x XLR |
| Frequency Response | 20 Hz - 20 kHz |
| Presets | User Presets |
| Control | Front panel, RS-232 |
| Power Supply | 100-240 V, 50/60 Hz |
To Next Page
