DSP 260
12 Owner‘s Manual
22 – Output Channel Mute Buttons
Each output channel has a lighted Mute button. Pressing the Mute button turns off the output of that
channel. The button lights red as an alert. Press the Mute button again to restore the output channel’s
signal.
Output channels may also be muted from the DSP 260 Graphic User Interface Application, if the unit is
connected to a PC. Muting a channel in any window of the application will light the channel Mute button on
the front panel of the unit as well.
23 – Output Channel Function Indicators
Each output channel has a four-segment function display for informational purposes only. For any given
configuration possible with the DSP 260, an output channel may be identified as a sub, low, low/mid, mid,
mid/hi, hi or full range output. One or two adjacent LED are displayed to indicate all possible output
bandpasses. (Full range is indicated by all lit LED’s.)
3.2 Rear Panel
24- A.C. Inlet
The DSP 260 features a standard IEC A.C. inlet that will accept universal power cords. The DSP 260
power supply is auto-ranging and can accept voltages from 100 - 240 V AC, 50 – 60 Hz. Only A.C. cords
approved for use in your country should be connected to the DSP 260.
25 – A.C. Fuse
The A.C. inlet includes a fuse holder that contains the mains fuse as well as a spare fuse. If necessary,
replace the fuse only with a specified 5x20mm, T800 mA, L250 V replacement. Disconnect A.C. power
before replacing a fuse. Before turning the unit back on, assess the condition of the A.C. receptacle
powering the DSP 260. If fuses continue to blow, refer servicing of the DSP 260 only to qualified service
personnel.
To Next Page
Loading...
Need help?
General
