Dynacord DSP 260 User Manual

DSP 260
10 Owner‘s Manual
10 – Store Button
Pressing the Store button while in Run mode displays the Store Preset screen in the LCD display and the
Store button lights. In this screen edited presets can be named and saved to a user preset location.
Pressing the Store button again completes the preset save operation.
To exit without storing the current preset, press the Edit or Setup buttons to return to the Run mode
screen.
11 – Recall Button
Pressing the Recall button while in Run mode displays the Recall Preset screen in the LCD display and the
Recall button lights. In this screen, any of the 60 factory and 20 user presets can be recalled into current
memory. Pressing the Recall button again completes the preset load operation and returns the LCD
display to Run mode.
To exit without storing the current preset, press the Edit or Setup buttons to return to the Run mode
screen.
12 – Input HPF Button
Pressing the HPF button places the current preset in Edit mode and jumps to the Hi-Pass Filter screen of
Input A. Subsequent button presses toggle the display between Input A and Input B.
13 – Input PEQ Button
Pressing the PEQ button places the current preset in Edit mode and jumps to the first screen of the Input
Parametric Equalizer. Subsequent button presses toggle the display between Input A and Input B.
14 – Input GEQ Button
Pressing the GEQ button places the current preset in Edit mode and jumps to the the Input Graphic
Equalizer screen. Subsequent button presses toggle the display between Input A and Input B.
15 – Input Delay Button
Pressing the Delay button places the current preset in Edit mode and jumps to the Input Delay screen.
Subsequent button presses toggle the display between Input A and Input B.

Dynacord DSP 260 Specifications

General

Brand	Dynacord
Model	DSP 260
Category	Signal Processors
Language	English