D 40 15
1.2 Preparation for transportation
- Use switch (1) to close the hopper.
- Engage both hopper transport safeguards.
- Lift the screed completely using switch (2), set the crossbeam lock.
- Turn the travel drive preselector (3) to zero.
- Fully extend the levelling cylinders with the switch (5).
A
To extend the levelling cylinders, levelling operating mode (6) must be switched
to "MANUAL" on the remote controls.
- Use switch (7) to adjust the screed to the basic width of the paver finisher.
m
Lift the auger if necessary!
A
If the engine is started with the drive lever pivoted out, the travel drive is inhibited.
To start the travel drive, first the drive lever must be returned to the centre position.
To Next Page
Loading...
