D 40 39
Flash sequence: 4-Pause-2-Pause-5.
Fault code: 425
A
If the output switch continues to be held in its upper position, the code is issued
once again.
A
Once the switch for error queries has returned to its 0 position, the warning lamp
which signalled the fault lights up again.
This continues until the corresponding error or malfunction has been rectified.
A
If several errors occur at the same time, the various flash codes are displayed next to
one another by pressing the output switch.
m
Notify customer service of the fault number displayed on your paver finisher: staff in
this department will then discuss with you what action to take.
To Next Page
Loading...
