Dynapac LP 650 - OPERATION - MANUAL START; Manual Engine Starting Procedure; Engine Stopping Procedure

16
LP 650/750 — ILP650EN1
OPERATION – MANUAL START
1. Make sure that the forward/reverse lever is in
neutral.
2. Make sure that vibration control is in neutral.
Starting the engine
1. Set the throttle to allow the engine to idle for a
minute or so.
2. Move the throttle to the bottom position to stop the
engine.
Stopping the engine
1
Controls
Engine
3. Set the throttle at full throttle.
3
4
4. Lift up the automatic decompression device to the
starting mode.
5. Turn over the engine with the starting-handle.
6. Allow the engine to idle a few minutes before rev-
ving up to full power.
Motor
Motor
L000018A
L000017A
L000015A
L000016A
2
1
2