Dynapac LP 650 - DAILY MAINTENANCE PROCEDURES; Scraper and Water Tank Maintenance; Joint Tightness and Washing Safety

22
LP 650/750 — ILP650EN1
MAINTENANCE – EVERY 10 HOURS OF OPERATION
Ensure that the scrapers are not touching the drums,
adjust if necessary to a clearance of 1 to 3 mm (0.04 to
0.12 in).
Scrapers
– Checking / Adjustment
Scrapers
1. Scraper blade
2. Screws
1
Check for any leakage from the machine.
Check that all bolted joints are tight.
Inspect the engine cooling system and clean as
required.
Keep the machine clean.
Never aim a water jet directly at the cap of the
fuel tank or hydraulic reservoir. This is espe-
cially important when using a high-pressure jet.
Do not spray water directly on electric components or
the instrument panel. Put a plastic bag over the filler
cap of the fuel tank and secure with a rubber band.
This will prevent water from entering the venting hole in
the filler cap. This could otherwise cause operational
disturbance, for example, a clogged filter.
L000020A
L000028A
L000011A
Control tighten bolts
Washing the machine
Screw off the tank cap (1) and fill with pure water.
Fill both water tanks; they hold 56 liters (15 gal) each.
Sole additive: A small amount of environment
friendly antifreeze.
Water tanks for the sprinkler system
Water tanks – Filling
L000012A
Bolted joints – Check
Washing (high pressure)
22