Dynapac LT6000 - Reassembly the Bellow; Changing the Bellows

To Next Page

To Previous Page

WLT6000-1EN1

REASSEMBLY THE BELLOW

Fig. 25 Rammer leg

1. Bellow

2. Bellow support

3. Outer tube

4. Outer tube

5. Pistonbolt

6. Hose clamps

Changing the bellows

1. Clean surfaces between bellow (1), bellow support

(2) and outer tube (3)

2. Change the bellows.

3. Refit the outer tube.

4. Align the machine and tighten the hose clamps (6).

Opposite directions for the hose clamps (6).

5. Mount the crankcase.

Tip!

Create an U-shaped tool made of 10-12 mm

plywood, so not the bellow presses down when

mounting the outer tube. See fig.

Fig. 26 Rammer leg

1. U-tool

W000029A

W000041A