28
Layer
B. Adjusting the LAYER VOLUME by using the LAYER VOLUME UP and DOWN buttons.
Adjust the layer volume.
Adjust the layer volume by using the LAYER VOLUME UP and DOWN buttons .
Return to the main menu.
Release the SETUP button.
If you press both VOLUME UP and DOWN buttons at the same time automatically return to the
default layer Volume(50).
The range of volume is 0 ~ 100.
Hold the button for continuous decrementing or incrementing.
If the DISPLAY HOLD is on, the pop-up display does not return to main menu and the LCD screen
shows the current pop-up display.
The DATA buttons or DATA wheel can adjust the volume instead of the VOLUME UP and DOWN
buttons 1n the volume pop-up display.
Call up the volume pop-up display.
Press and hold down the SETUP button and press LAYER VOLUME UP or
DOWN button. The Volume pop-up display appears.
CHANGING THE PEDAL OPTION
This determines whether the damper pedal and assignable pedal affects the layered voice in layer function.
Select the pedal option.
Change the pedal option by using the DATA buttons or the DATA wheel.
If you press both the DATA UP and DOWN buttons at the same time automatically return to the default value (ON).
If the DISPLAY HOLD is on, the pop-up display does not return to main menu and the LCD screen shows the current pop-up display.
Call up the layer mode. To call up the layer mode, press the LAYER button. Lamp lights and
the layer is set on. The layer pop-up display appears.
Move the cursor to the pedal value in the layer pop-up display.
Press the YES button
in the layer pop-up display until the cursor goes to the pedal option.
Return to the main menu.
Press the NO button.
Even if you don't press the NO button, the pop-up display automatically returns to the main menu after 3 seconds. But if the
Display hold is on, you should press the NO button to return to the main menu.
CHANGING THE OCTAVE SETTING OF THE LAYERED VOICE
The octave shift setting lets you adjust the pitch of the layered voice. In the meantime, the octave shift
setting can be adjusted in the octave shift setting function. See the OCTAVE SHIFT section on page 39 .
Select the octave option.
Change the octave option by using the DATA buttons or the DATA wheel.
If you press both DATA UP and DOWN buttons at the same time automatically return to the default value (0). Range -1~0,~+1
If the DISPLAY HOLD is on, the pop-up display does not return to main menu and the LCD screen shows the current pop-up display.
Call up the layer mode. To call up the layer mode, press the LAYER button. Lamp lights and
the layer is set on. The layer pop-up display appears.
Move the cursor to the octave value in the layer pop-up display.
Press the YES button
in the layer pop-up display until the cursor goes to the octave option.
Return to the main menu.
Press the NO button.
Even if you don't press the NO button, the pop-up display automatically returns to the main menu after 3 seconds. But if
the Display hold is on, you should press the NO button to return to the main menu.
To Next Page
Loading...