You can use the DATA UP and DOWN buttons instead of the REVERB DEPTH UP and DOWN buttons.
If you press both UP and DOWN Buttons at the same time automatically return to the default reverb
depth of each part. (default Main Voice 70, Layer Voice 70, Split Voice 70, Chord parts 70, Bass 20, Drum 40)
The range of volume is 0 ~ 100.
Hold the button for continuous decrementing or incrementing.
If the DISPLAY HOLD is on, the pop-up display does not return to main menu and the LCD screen
shows the current pop-up display.
The DATA buttons or DATA wheel can adjust the volume instead of the VOLUME UP and DOWN
buttons in the pop-up display.
The reverb depth pop-up display can be called up from the reverb pop-up display.
When the LCD screen shows the reverb pop-up display, press the YES button. The reverb depth pop-up
appears.
33
Reverb
ADJUSTING THE TOTAL DEPTH
This determines the total depth of the reverb.
Call up the SETUP mode.
Press and hold down the SETUP button. The setup pop-up appears in the LCD screen.
Adjust the total depth.
Adjust the total depth by using the REVERB DEPTH UP and DOWN buttons .
Return to the play mode.
Release the SETUP button.
If you press both UP and DOWN buttons at the same time automatically return to the default
reverb total depth (50).
The range of volume is 0 ~ 100.
Hold the button for continuous decrementing or incrementing.
If the DISPLAY HOLD is on, the pop-up display does not return to main menu and the LCD screen
shows the current pop-up display.
The DATA buttons or DATA wheel can adjust the volume instead of the VOLUME UP and DOWN
buttons in the pop-up display.
ADJUSTING THE DEPTH FOR EACH PART
The reverb part depth parameter lets you make different reverb depth setting for
the rhythm, bass and chord parts of the auto-accompaniment, as well as the
parts you play from keyboard.
Call up the SETUP mode.
Press and hold down the SETUP button. The setup pop-up appears in the LCD
screen.
Adjust the depth of the selected part.
Adjust the depth of the selected part by using the REVERB DEPTH UP and
DOWN buttons .
Move the cursor to the desired part.
Press the YES button until the cursor is located on the desired part.
Call up the reverb depth pop-up display.
Press the REVERB DEPTH UP or DOWN button. The reverb depth pop-up appears.
Return to play mode.
Release the SETUP button.
To Next Page
Loading...