DyneSystems DS820F - Customer-Supplied Controller Configuration

Conguration
CONFIGURATION (CONTINUED) CONFIGURATION (CONTINUED)
--" x --" x --"
TRANSFORMER
POWER
--- LBS
FIELD
T1
SINGLE PHASE CUST xxxVAC
xxxVAC @ xxA CONDUIT P2*
-- KVA
xxxVAC @ xxA CONDUIT P3* FACILITY VAC
xxxVDC @ xxA EC DYNO FIELD CONDUIT P5*
FLOW OR PRESSURE OR TEMP H20 SAFETIES - CONDUIT S3*
~40 LBS
xxA
ECPAU
20" x 16" x 8"
xxxVAC @ xxA ISOLATED VAC CONDUIT P4*
FACILITY VAC
+ GROUND
DISCONNECT
xxxVAC @ xxA CONDUIT P1* FACILITY VAC
__"x__"x__"
MIDWEST MW-xxxx
CONDUIT S1* SPEED/TRQ FB
CONSOLE
ECPAU CONTROL CONDUIT S2*
TEST CELL
MINIMUM SPACE OF 12"
ON EITHER SIDE OF ECPAU
LOAD CELL
115VAC @ 15A FACILITY VAC CONDUIT P6*
MAG PU
DISCONNECT
CNTRL XFMR
---/---
---KVA
---LBS
-"x-"x-"
FOR COOLING AIR FLOW
OPTIONAL(IF 115VAC NOT AVAILABLE)
J BJ B
J B
EC DYNAMOMETER
HP xxxxHP ABSORB
RPM xxx/xxx
FIELD xxxV @ xxA
xxxVAC @ xxA FACILITY VAC CONDUIT P7*
CUSTOMER SUPPLIED
CONTROLS
Figure 2.3 - Customer-Supplied Controller, 0-10 VDC or 0-20mA Control Signal with Wall Mount ECPAU (Optional Rack Mount)
Dyne Systems • DS820F PAU
DPD-001-04B • © Copyright Dyne Systems, Inc.
7