14
Installing the Flight Battery
Use the included hook and loop material for mounting the Li-Po battery pack. The “hook” material is already installed
on the battery frame stop. The included “loop” material can be installed on the end of the battery with or without the
wire leads, depending on how you choose to install the battery and route the wire leads.
If you choose to install the loop material on the end of the battery with the wire leads, it will be a little more difficult
to install the battery in the model but the wire leads can be tucked neatly inside of the body.
If you choose to install the loop material on the end of the battery without the wire leads, it will be easier to install
the battery in the model but the power leads (red and black leads with red JST connector) will need to be placed
outside of the body.
The battery can be installed through the opening in the rear of the body. Be sure to install the end of the battery
with the loop material first. If you have installed the loop material on the end of the battery with the wire leads,
be sure that the wire leads are oriented to the left side of the model so that they can pass by the stop. Slide the
battery into the support frame until the hook and loop material makes contact.
To Next Page
Loading...
