23
Installing the Optional Training Gear
If the Blade™ CX2 is your first helicopter model, we suggest that you install the optional Training Gear Set
(EFLH1205) before making your first flight. The training gear helps to further increase the stability of the model
while also providing added support and cushioning to prevent tip-overs and damage to the model from abrupt
landings.
Installing the training gear takes only a few minutes following these steps:
• The Training Gear Set includes four training gear rods with plastic balls installed, four training gear rod to landing
skid attachments, four screws and one training gear rod mounting base.
• Locate the four training gear rod to landing skid attachments and four screws. Note that there are two each of
two types of attachments. Carefully snap two of the attachments onto the landing skids forward of the landing
skid struts. The side of the attachment with the large hole should face outward, away from the helicopter, and
forward to the front of the helicopter.
• Next, carefully snap the remaining two attachments onto the landing skids behind the landing skid struts. The
side of the attachment with the large hole should face outward, away from the helicopter, and backward to the
rear of the helicopter.
To Next Page
Loading...
