E-FLITE BLADE CX2 - Pre-Flight Checklists

7
Preparing for the First Flight Checklist
Please note this checklist is not intended to be a replacement for the content included in this instruction
manual. Although it can be used as a quick start guide, we strongly suggest reading through this manual
completely before proceeding.
 Remove and inspect contents
 Charge the flight battery
 Install the 4 included “AA” batteries in the transmitter
 Install the flight battery in the helicopter (once it has been fully charged)
 Check the center of gravity of the helicopter
 Test the controls
 Install the optional Training Gear Set (EFLH1205; strongly recommended if this is your first helicopter model)
 Familiarize yourself with the controls
 Find a suitable area for flying
Flying Checklist
Please note this checklist is not intended to be a replacement for the content included in this instruction
manual. Although it can be used as a quick start guide, we strongly suggest reading through this manual
completely before proceeding.
 Always turn the transmitter on first
 Plug the flight battery into the 4-in-1 control unit
 Allow the 4-in-1 control unit to arm properly
 Fly the model
 Land the model
 Unplug the flight battery from the 4-in-1 control unit
 Always turn the transmitter off last