42
• With the right-hand main motor removed from the frame, you can press the main motor heat sink into place near
the top/end of the left-hand main motor. We recommend that you use Heat Sink Compound (EFLM1913) on any
surfaces of the heat sink that make contact with the motor case to further improve the effectiveness of the heat
sink. The wider end of the heat sink (more fins) must be placed toward the front of the helicopter.
• You can now press the right-hand main motor into place in the heat sink and use the motor mounting screws
to re-install the motor on the main frame. Again, we recommend that you use Heat Sink Compound (EFLM1913)
on any surfaces of the heat sink that make contact with the motor case to further improve the effectiveness of
the heat sink.
The main motor heat sink is now installed and ready for flight.
To Next Page
Loading...
